[Kung_fu_eddy]

Just wanted to share the numbers I've made on the SRT Max Plus cam. I installed my cam over quarantine and got some initial numbers.

These runs were CAI, Borla Catback and SRT Max Plus on an AWD DYNOJET. 363AWHP 355AWTQ

I have since installed Kooks LTs, HHP Ported Intake, and UD pulley. I was able to get 1 run in today on another AWD DYNOJET before we started having traction control issues. We did a 3rd gear pull but it shifted towards the end so we zoomed that part of the graph out so I apologize for the less than good read out. Results were 410AWHP and 393AWTQ

Very happy with the gains especially surprised by how much the headers and intake helped out the cam set up. Looking to run a RWD run on the same dynohet next time and hopefully get 3 full runs with no issues.

 

[Superchargedss]

Any plans to run this at the track?

 

[Kung_fu_eddy]

Definitely. Unfortunately the tracks in my state are closed due to covid so I likely won't be able to run until next year.

 

[mondo]

Did you do 3rd gear pulls on the first dyno print out also?

 

[Kung_fu_eddy]

I can't remember if the first graph was 3rd or 4th gear pulls. Is there a significant difference when done in different gears?

 

[mondo]

I'm pretty sure 4th gear is the 1:1 ratio

 

[Kung_fu_eddy]

Good to know. I'll ask to do a pull in each gear next time for comparison.

 

[mondo]

Good gain on numbers though. I bet it sounds good too. Did you do catless or high flow mids?

 

[Kung_fu_eddy]

Thanks! I used High Flow cats and it's about as loud as I would want it. Though I wouldn't mind it chopping more at idle if I had gone catless

 

[mondo]

What do you have the idle set at?

 

[07ginger]

Very nice, the UD pulley worth it ?

 

[Kung_fu_eddy]

What do you have the idle set at?

I think it is at 850 rpm right now. I tried setting it lower and I would get an idle surge sometimes so I left it back to what Johan had set it at.

 

[Kung_fu_eddy]

Very nice, the UD pulley worth it ?

I would say so. The pulley is much lighter and it's a cheap mod if you have the pulley tools.

 

[mondo]

I think it is at 850 rpm right now. I tried setting it lower and I would get an idle surge sometimes so I left it back to what Johan had set it at.

Just curious because I couldn't go any lower than 750 on my pwr 224r cam back in the day. It would surge when going from D to R and back. Sometimes would stall also. At that time Johan was doing the tuning also. Check to see if he can make changes to lower rpm.

 

[tony.singh]

Who are you guys getting your tunes from?
I just had the SRT Max cam installed and am having a hard time finding someone to tune it.
I also picked up a Diablo inTune i3 and have pulled the stock tune file.

Thanks!