[Shaggy1421]

Recently had a brake job done at a shop after I got the jeep back service traction control suspension and abs lights on. No traction control , no suspension operating in 2wd. Any ideas I have done lots of reading but can’t find anything that helps. Replaced one abs sensor after I inspected it and broke it now it’s saying improper part installed.

 

[WUNFSTSRT]

Did you try taking it back and asking them why the codes were there after the brake job?

Try and have the ECM/ TCM scanned if any codes are present.

Check all the ABS sensors and check the harness on each in case they are rubbing on the wheels or something.

 

[Shaggy1421]

Did you try taking it back and asking them why the codes were there after the brake job? Try and have the ECM/ TCM scanned if any codes are present. Check all the ABS sensors and check the harness on each in case they are rubbing on the wheels or something.

yeah I brought it back they said it had nothing to do with them. They said it was a module under the centre console. They replaced it and it didn’t change anything now they have ordered another module can’t exactly recall what it is but it’s been a month and they haven’t received it. Mostly what I have read is abs sensors but cannot visually see any broken wires. The one I did replace is now not reading after install and says it’s the wrong part installed it is not a mopar part but I have confirmed it’s the right sensor and installed properly. I pulled the battery last night to do a load test as it seems some guys had issues with that.