Our 2010 has no grease fittings. I see no problem with replacing with grease fitting equipped replacements as long as you maintain them. I drove vehicles for 40 years with front end components with grease fittings and if you regularly grease them they essentially never wear out under normal use.
Questions about steering and front end
So I been looking at replacing tie rods to see if that will help with my sloppy steering. I noticed on rock auto that all the replacement parts are greasable ones, are the factory one too? Could this be the reason for sloppy/floating steering? Also looking at doing upper and lower ball joints too, is this a point I should address as well to tighten up the front end?
Sent from my Autoguide iPad app
Sent from my Autoguide iPad app
1 - 1 of 5 Posts
1 - 1 of 5 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Cherokee SRT8 Forum
Our Jeep Grand Cherokee SRT8 Forum is a community dedicated to Jeep enthusiasts to discuss specs, horsepower, reviews and more!
Full Forum Listing
Recommended Communities
