P2138 code... flashing ETC light

1652 Views 2 Replies 2 Participants Last post by pimpski25, Dec 19, 2011

pimpski25

Discussion Starter · Dec 19, 2011

i looked up the code and it states "accelerator position sensor circuit range/performance. i had no throttle response.... i could drive t home but i couldnt push the pedal down more than a half inch or else i would completely lose power. which sensor is this? pedal? throttle body? anyone have similar issues???

Save

1 - 3 of 3 Posts

[email protected]

· #2 · Dec 19, 2011

Make sure your TB is tight. Just had a friend go through this and the TB was loose and catching the blade and holding it open. Just a thought.

J

Save

pimpski25

Discussion Starter · #3 · Dec 19, 2011

[email protected] said:
Make sure your TB is tight. Just had a friend go through this and the TB was loose and catching the blade and holding it open. Just a thought.

J

thanks... that helps... i'm hoping it is a fix that can be corrected without having to buy any parts... hopefully just an adjustment... so i will check it out today!

Save

1 - 3 of 3 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month