Cherokee SRT8 Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Greetings all,

I was hoping someone could help me out by confirming a few BCM settings in their WK1 for me, reading them out with AlfaOBD or some equivalent. I'm looking to match the settings for T-case type and drivetrain configuration (let's not worry about why just yet 😉). MY08 would be preferred, but I think any SRT8 WK1 should be set up the same way. If anyone's in the Detroit area, I could also come meet you and help with reading out the settings.

Also, does anybody know where I might find a wiring diagram for the SRT8 FDCM and NV146 Actuator? All of the factory repair manuals I've been able to find only cover the NV245 setup. So far I've been working under the assumption that the pinouts are the same between them, since the connectors are the same.

Any help would be greatly appreciated!
 
1 - 1 of 1 Posts
Top