Thank you so much this worked for me as always you guys are the best
Drains are all located in the bottomWhere do the sun roof drains exit? I saw a video of a Commander I believe. It had the drain under the dead pedal. I can see the drain line when I take the panels off by the hood lever. I can't find the exit though. I'm sick and tired of the A pillar and every pillar pissing water. Help
Sent from my iPhone using Tapatalk
thanks, just bought a used commander and water leaked through the sunroof when my wife took it through the carwash for the first time. I noticed the sunroof did not close the last 1-2 mm. Did the reset and it closed all the way. All is good! thanks!Recently, I noticed that my sunroof was not closing flush with the roof but was otherwise working properly. Not by much, but there was enough room for water to get past the seal. I took the rig to the dealership. They charged me $110 to diagnose. They told me I had a bad module, it was not covered by the extended warranty, and it would cost me $675 to fix. I said nevermind and took the rig home, $110 poorer.
I got online and found a TSB from 2005 that explains how to recalibrate the sunroof. I did it, and now it closes like its supposed to.
Just follow steps 7-12 at the bottom of this TSB:
Link has disappeared this just saved the day! Thanks mateAwesome!
JUST performed the re-cal and it worked beautifully. I was dreading another trip to the stealership fight::flamed::bananahump-slvrathl) and now I don't have to thefinger: :silly: :nofu!
~copying and pasting from the .pdf (the RUN position is the ON position;i performed step 12 a total of 9 times)
7. Place the ignition switch in RUN position.
8. Close all of the doors.
9. Press and release the vent switch (sunroof should move to vent position).
10. Once the sunroof has stopped motion at the vent position, press and hold the vent switch
for at least 5 seconds to recalibrate the sunroof position.
11. If the sunroof did not reach the full vent open position, press and hold the vent switch until
the full-vent-open position is reached then release the vent switch, then press and hold the
vent switch for at least 5 seconds to recalibrate the sunroof position.
12. Cycle the sunroof from the full-vent-open position to the full-slide-open position and back to
the full-vent-open position at least 7 complete times. The sunroof is now in customer mode
with the obstacle detection thresholds updated.
I vote sticky thread and get this man a t-shirt and sticker! imp: :bigthumb: