Cherokee SRT8 Forum banner
1 - 2 of 2 Posts

·
The Traveler
Joined
·
5,264 Posts
A little Google goes a long way ;)



2007 service manual - Nag 1 transmission.

U0114-LOST COMMUNICATION WITH FINAL DRIVE CONTROL MODULE
For a complete wiring diagram Refer to Section 8W

Theory of Operation


The Transmission Control Module (TCM) receives information from the Engine, Anti-lock Brake System, and the Electronic Gear Shift control modules over the CAN C bus. The CAN C bus is a high speed communication bus that allows real time control capability between various controllers. Most messages are sent every 20 mSec, this means critical information can be shared between multiple controllers almost instantaneously. The CAN C bus is a two wire bus with a CAN (+) and a CAN (-) circuit. To reduce the potential of radio and other electrical noise interference, the CAN Bus circuit wiring is manufactured using a twisted pair configuration within the electrical wiring harness.



When Monitored:
Continuously with the ignition on.

Set Condition:
The DTC will set if a valid CAN ID was not received in the required time from the Final Drive control module.


Possible Causes

TRANSMISSION CONTROL MODULE



--------------------------------------------------------------------------------

Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding. (Refer to 21 - TRANSMISSION/TRANSAXLE/AUTOMATIC - NAG1 - STANDARD PROCEDURE)




Diagnostic Test
1. CHECK THE FCM FOR CAN C BUS COMMUNICATION DTCS
--------------------------------------------------------------------------------

With the scan tool, check for FCM DTCs.

Does the FCM report the DTC U0001-CAN C BUS DTC or U0114-LOST COMMUNICATION WITH FINAL DRIVE CONTROL MODULE?

Yes

(Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - DIAGNOSIS AND TESTING) category and perform the appropriate symptom. Perform the diagnostic procedure for U0001-CAN C BUS first if it is present.
Perform NAG1 TRANSMISSION VERIFICATION TEST. (Refer to 21 - TRANSMISSION/TRANSAXLE/AUTOMATIC - NAG1 - STANDARD PROCEDURE)


No

Go To 2

2. CHECK IF THE DTC IS CURRENT
--------------------------------------------------------------------------------


NOTE: When the Transmission Control Module (TCM) detects and stores a DTC, the TCM also stores the vehicles operating conditions under which the DTC originally set. This information is located in the scan tool under Environmental Data. Before erasing any stored DTCs, record any available data to assist in duplicating the conditions in which the DTC originally set.


Ignition on, engine not running.
With the scan tool, erase Transmission DTC's.
Using the Environmental Data recorded earlier, try to duplicate the conditions in which the DTC originally set. It may be necessary to test drive the vehicle.
With the scan tool, read Transmission DTC's.

Did the DTC U0114-LOST COMMUNICATION WITH FINAL DRIVE CONTROL MODULE reset?

Yes

Using the schematics as a guide, check the Transmission Control Module (TCM) pins, terminals, and connectors for corrosion, damage, or terminal push out. Pay particular attention to all power and ground circuits. If no problems are found, replace the TCM per the Service Information. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES/TRANSMISSION CONTROL MODULE - REMOVAL)
Perform NAG1 TRANSMISSION VERIFICATION TEST. (Refer to 21 - TRANSMISSION/TRANSAXLE/AUTOMATIC - NAG1 - STANDARD PROCEDURE)


No

Go To 3

3. INTERMITTENT WIRING AND CONNECTORS
--------------------------------------------------------------------------------

The conditions necessary to set this DTC are not present at this time.
Using the schematics as a guide, inspect the wiring and connectors specific to this circuit.
Wiggle the wiring and connectors while checking for any possible open or shorted circuits.
Check for any Service Information Tune-ups or Technical Service Bulletins that may apply.

Were there any problems found?

Yes

Repair as necessary.
Perform NAG1 TRANSMISSION VERIFICATION TEST. (Refer to 21 - TRANSMISSION/TRANSAXLE/AUTOMATIC - NAG1 - STANDARD PROCEDURE)


No

Test Complete.



Sent from my iPhone 4S
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top