I’m about to buy the Demon hood for my 2013 SRT8. What prep needs to be done prior to install? Can it just be wrapped, if primed already, or must it be painted, or just clear coated? Gonna have the entire Jeep wrapped anyway...

So I just picked up my ‘13 JGCSRT8 about a month ago. I know it’s running rich because the tailpipe is full of soot. I need to find someone who can tune it properly. I’ve also thought of doing a cam swap but will do a little more research first. I want to do both at the same time. If I need to...

This should apply to any spring install, but in my case I'm removing the Road Magnets and installing the H&R Grand Cherokee Springs. These are not designed specifically for the SRT8, but I need better handling for my daily driver and they are supposed to be an improvement over stock and still...

The band of NITWITS are at it again. We will be installing Cam, Ported Intake Manifold and the first of its kind Custom Heads on my JEEP on Saturday Sept. 29th in Marysville, WA. Wrenching starts @ around 9AM. Let me know if you want to come through and I'll send you the address. Come check...

This is the installation of the Borla ATAK exhaust. Time: 1-2 hours Tools: Floor Jack Jack Stands Creeper (Or a lift and not the above) White Lithium Spray Grease Torque Wrench with Deep 15mm Socket Ratchet Wrench Pry Bar Exhaust Cutting Tool Flash Light Maybe a buddy (did mine by myself)...

12V 35w Slim Digital Ballast 6k H11 HID Fog Lights. Time: 2-4 hours Parts: Self Taping Metal Screws Zip Ties Tools: Soldering Iron Solder Electrical Tape Wire Loom Heat Shrink Lighter Wire Strippers Diagonal Cutters Digital Multimeter Drill 1/8th Drill Bit Few Small Metric Sockets Ratchet...

Forum, I'm having a problem with my right front lowbeam. When I start my '08 SRT8, the right light blinks, or flickers rather, for about 20 seconds then it appears to turn off, leaving only a type of glow (that I assume must be from the turn signal light) illuminating orange/yellow somewhat...

Hi all, I left my truck this morning with my dealer (no shop knows our rigs better around here unfortunately...) to have an SLP Underdrive Pulley installed. Unfortunately, they called back later saying they could not install it, as the part of the pulley that sleeves the crank is notched...

Pics of 2008 Jeep SRT8 new install with very little cargo area used! This project was a successful one with very little space used>>>>2 10inch L7 Kickers, Matched the factory color leather & stitching, 1 Kenwood KAC-1023 1200watts OLD School amp, 1 deep cycle high current Battery, & 2 capacitors...

Getting my Headers installed on Friday , so for those who has done it or knows anything about it , your input will be much appreciated . Anything that can make the install easier than trying to school our self's ;) Joyeclutch you're next in line so get with the program here hehe . Thanks in...