Cherokee SRT8 Forum banner
borla
1-20 of 35 Results
  1. WK2 SRT8 General Discussion
    Hello everyone ! Been a while but finally I have decided to go with solo exhaust for my 2018 SRT. Did a couple forums before but just some final questions so please chime in if you own or heard this exhaust before on a WK2 ! Acceptable for daily ? Don't want the loudness when I'm tired so is...
  2. WK2 SRT8 Intake/Exhaust Discussion
    Hello, I have a 2016 Jeep SRT with Borla ATAK Cat-back Exhaust right now. Looking to put a header and mid-pipe that fits with my Borla ATAK cat-back. I am looking at Kooks headers and non-catted mid-pipe are 3'' and I think my Borla is 2.75'' (not sure if they can fit) has anyone installed the...
  3. Parts For Sale/Wanted
    Selling my Borla ATAK cat back exhaust system - Part# 140633. The system is brand new and was just taken out of the box to take pictures. Fits 2015-2018 SRTs. Asking $1,000, buyer pays shipping ($150 est). I'm located in the Bay Area, CA so local pickup would be preferred. You will need to...
  4. PK Auto Design
    Good morning ladies and gents, We here at PK Auto Design always strive to provide our car communities the best products, service and knowledge available. Not only do we offer the ability to provide the best brands in the market, but also the ability to provide some of the most competitive...
  5. WK2 SRT8 Intake/Exhaust Discussion
    Ok, after lots of consideration, help from members here, and countless hours browsing exhaust clips on youtube, I finally went with the ATAK axle back. Easy to install, and love it. A couple things: 1) It's really annoying that people post clips on YouTube and they don't say if they have axle...
  6. WK2 SRT8 Intake/Exhaust Discussion
    I know this has been discussed in various threads, but for both me and future users to more easily find an answer, I would love to hear tips & tricks about getting the Borla systems aligned perfectly. I just got my S-Type installed and the top of the exhaust tip sticks out about 1/4" past the...
  7. Parts For Sale/Wanted
    This setup was on my 2014 Jeep Grand Cherokee SRT for 7,500kms. I had the X-pipe custom built (steel) and made to connect to the Borla ATAK 5" rear section (stainless steel). Comes with the necessary clamps for an easy install. As with all Borla Jeep exhausts, perfect fitment requires a bit of...
  8. WK2 SRT8 Intake/Exhaust Discussion
    Hey all I have a 2014, all drive line components are stock at this point. Looking for input on doing an exhaust upgrade, my questions are pretty specific to the list below. I am looking to get some nice sound out of the vehicle, not window/ear shattering, but I want to be able to hear/feel the...
  9. Cars For Sale/Wanted
    Hate to do this, but I just bought a boat and need a truck to pull it. I'm selling my 2012 Jeep Grand Cherokee SRT8 with 62,500 miles (still driving). I've had it for the past two years and it has really been awesome. Tows well, handles snow and of course isn't too slow either. I've kept it...
  10. Parts For Sale/Wanted
    I had this exhaust on my 2015 SRT for about 2 months, less than 1000 miles. It looks brand new, sounds awesome. I read a few posts where guys said the S type isn't much different than stock but that is not the case, at all! This axle back changes the sound dramatically on my 2015. The only...
  11. WK2 SRT8 General Discussion
    So I made a boneheaded decision last week to have a shop cut off the resonators and "weld" the tips back on. I had been looking for a more aggressive tone and thought I would go this route and change it up if I didn't like it. Long story short is that it got jacked to hell and looked horrible...
  12. Parts For Sale/Wanted
    Looking For A Full Corsa Or Borla Catback Exhaust For A WK1 (06-09 SRT8) Anybody Have One?
  13. Parts For Sale/Wanted
    Hey guys, wanted to throw these few things up, just did a clean out of the garage and figure i'd put these up and see if there is anyone who wanted to upgrade, or go back to stock. Stock Exhaust $150, prefer local pickup but if shipped buyer pays shipping, less than 30k on it. OEM...
  14. Parts For Sale/Wanted
    Cleaning out the shed for spring and have the following up for grabs: Winter tire and wheel setup: Pirelli Scorpion ice and snow 255-55r18 on Sport Edition wheels, have TPMS installed and are runflats. Ran for first winter I owned the Jeep and have tons of tread remaining. Asking $1200.00...
  15. WK1 Troubleshooting / Problems Discussion / Dealer
    Everytime i run my truck at 65+ the temp runs up to about 230-235 I got a jet 180° tstat but dont have a tuner & i have heard that it is common for them to get stuck... Problem only happens at 65+ any idea what it could be the cause of this?
  16. Quadratec
    Your factory exhaust sounds good, but you can have it sounding great! We offer some high quality upgrades for your SRT8 exhaust from name brands such as Borla, Corsa and Magnaflow. Check 'em out here: WKII Borla S-Type rear (Louder than stock, but not crazy loud): WKII Borla ATAK rear...
  17. WK1 Troubleshooting / Problems Discussion / Dealer
    I recently added a 1.1F/1.8R road magnet lowering spring kit on my 06 and the ride is terrible.. so im guessing it's the shocks... Any idea on what are the best one's to fix my problem?
  18. WK1 Intake / Exhaust Discussion
    Hello fellow Petrolheads, Currently I am running Kooks lt headers to catted mid pipes to a Borla S cat back. I am Thinking about cutting the mufflers in the middle of the jeep so closest to the cats out. Has anybody done that? How does it sound? That section of the pipe will be replaced with...
  19. WK1 Troubleshooting / Problems Discussion / Dealer
    Hey, So the other day i put on kooks lt headers with catted mid pipes i also hooked up a diablosport trinity with no custom tune. My jeep now misfires on cylinders 2 4 6 8 so passenger side of the engine. IT doesn't misfire when you have your foot to the floor only at idle and low rpm cruising...
  20. WK1 Intake / Exhaust Discussion
    Hey Guys, I recently put on kooks lt headers with catted mid pipes that runs to a borla s cat back exhaust i have y pipes i want to put in to run cut outs of of but don't know where there is enough room for them. Can somebody please give me an idea. Thanks, Peter Couillard
1-20 of 35 Results
Top