installed my SOLO :)

[jeep2006]

install was easy it ur good with tools. gotta give them old bolts some WD-40 and some heat from a torch. after that simple as pull out and cleaned up wear the muffler meets the cats. straight forward. had my friend push as hard as he could on the passager side to have it nice and level. Have NOT adjusted the pipes yet. on the expressway it gets loud at like 80/85 plus

[jvs0302]

nice! I have a Solo and am loving it. nice job on your install.

[jeep2006]

Thanks just getting use to it but I love it now more and more


Sent from my iPhone using AutoGuide.com Free App

[Mike05V]

Loving mine too. I did adjust the J pipes as I described in the "big" Solo thread in the vendor section. It's cool because you can tune the thing to how your like it, adjust as you add mods, etc. I have mine setup with the J's slid in 1" from factory location. I get more burble on decel and better throttle response now. This is with Mopar CAI and canned Diablo tune.

I wish I had someone around when I did the install because my left tip sits just a bit higher than than the right. I wonder if I loosed up the connections and put a jack under the right side then tightened if that would work.

[jeep2006]

U might. But an extra person will do it. U kinda have to twist it up little by little . First by the muffler then by the center


Sent from my iPhone using AutoGuide.com Free App