Cherokee SRT8 Forum banner

Anybody recognize these cut-outs?

1K views 8 replies 3 participants last post by  CentralTexHemi 
#1 ·
repost - I know - but I didnt get any response

I got my 06 with the cut-outs welded in and blanked off to pass inspection. They are rectangular... There is a 2 wire w/connector on the end run to each and under the dash there is a 4 wire connector. No butterfly valves or controller...Does anybody know what make or brand would fit here so I can buy some replacement parts and a controller that will plug right into this type of setup
 

Attachments

See less See more
2
#4 ·
Yeah, I dont really like either of those... Wiring and welding are done though- If I was to start over that would have to be re-done. I'll just leave it for now I guess unless some parts are available for easy bolt on
 
#8 ·
Those have to be them! Do u think they are still around? I need the butterflys and a controller! Sweet
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top