Cherokee SRT8 Forum banner

Time Slips-Quickest/Fastest N/A SRT8 Jeep

4K views 24 replies 13 participants last post by  sarge 
#1 · (Edited)
I wanted to make sure the time slips were available for "official" record and to leave no doubt that the SPP Jeep is the quickest and fastest N/A 426 SRT8 Jeep in the Nation...:Dso far. No turbo's, quad superchargers, 200 shot of nitrous or -2000 DA weather conditions. The power is obviously very consistent and not a one time event. Not bad for a 5,000lb vehicle with a 245lb driver! The two slip groups reflect different tunes installed.

This record was accomplished at Famoso Raceway and official NHRA Track.
http://www.famosoraceway.com/map.htm
The track is 635' above sea level

Conditions around 2:00pm were(time on slips was one hour ahead/not set for actual daylight savings time)
53.7/38.4/29.63/56% DA was +872
http://www.wunderground.com/weatherstation/WXDailyHistory.asp?ID=KCABAKER23

http://wahiduddin.net/calc/calc_da.htm

Time slips reflect three (3) consistent back to back runs



After vehicle cool down/reinstalled the RDP Tune

 
See less See more
2
#5 · (Edited)
Cam and I are going to put together a private track day for the first or second week in January. We will be looking for 20-25 cars.......so get your camera ready. By then I should have the Platinum Series Gen2 Mondello heads!!

I only stick to the facts.....quickest/fastest N/A SRT8 Jeep....for now.
 
#7 ·
Thanks!!




ERIC!!!!

You know first hand all the issues i had with the RDP tune! I was taken by the whirlwind tuning tour.....only to be disappointed. After data logging and watching my engine detonate itself constantly......burning plugs....surging....the engine ready to jump out of the engine bay!! I recently pulled out and had all the injectors ultra sonic cleaned and balanced and installed new spark plugs just to have it do the same old crap!!

Bob from SVS is the man. Those LX cats have been doing this longer than us and they have the right guy for those "out of stock" builds.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top