Bwoody Washer Tank Fix WK2 - Page 7

barish93 · #61 10-09-2012, 06:08 AM

I have a tough time believing that the intake you are talking about gives a 30 horsepower increase according to their website.

Sent from my iPhone using Autoguide

**cyanideg** · #62 10-09-2012, 10:59 AM

I shelled out over $500 for a CAI from Bwoody. I ordered the candy red but when the package came there was a black tube... I contacted them and they had me send it back, then they sent me the red one, no big deal just had to wait like another week... At no point before or after the purchase did they tell me that the OEM washer functionality would be messed up. What a joke. On top of all this the bracket that connects the air tube to the front bumper section down by the air filter busted off the tube probably from engine torque. I emailed them several times without a response. I would have figured they would at least say something to me but NOPe nothing. screw them, ill not be buying any BWoody crap again.

steveSRT · #63 12-11-2012, 03:42 PM

Ok guys sorry it took me so long to get these pics up, life is always a hectic thing. I still need to get the tank anodized red but this is what my friend fabbed out of aluminum for me, uses the factory washer pump so both front and rear sprayers work by themselves.

Bono392 · #64 12-11-2012, 10:26 PM

Nice one! I'm just about to fit my Bwood intake and need to sort a bottle of some kind - Assume no other update from them as to a solution? (aware of Zac's one, but just curious as to other options - ideally keeping factory pumps as done here.. Cheers!

**Mongoose9400** · #65 01-17-2013, 05:18 PM

This is about the only way to extend it and make it larger. The height is pretty much maxed out with a small gap between the bottle and bwoody CAI. The width doesn't allow much room either.

Bono392 · #66 01-17-2013, 05:49 PM

Cheers Zac! So I take it the bottle is currently about 4.5" deep (shown) x 5.5" wide? Any idea of vertical height? Maybe 6.5"? Will help finding a suitable equivalent over here

Thanks!

**Mongoose9400** · #67 01-17-2013, 05:56 PM

Quote:

Originally Posted by Bono392

Cheers Zac! So I take it the bottle is currently about 4.5" deep (shown) x 5.5" wide? Any idea of vertical height? Maybe 6.5"? Will help finding a suitable equivalent over here

Thanks!

6" wide. 5" deep and 7" height plus the fill neck which sits another 1/2" tall or so.

Sent from my iPhone using AutoGuide.com App

**CopRodder** · #68 02-07-2013, 10:43 AM

You could run a hose from top to bottom where u plugged it to use as fluid level guage thenpaintbtank to match engin bay
But it's a great idea and a solution that bwoody should of been able to do