Guys I need some help, I'm installing a PWR 224 cam as we speak, the same as mondo and was wondering how I slide the cam in? It's +4, does it go straight In or do I have to set it?
Guys I need some help, I'm installing a PWR 224 cam, the same as mondo and was wondering how I slide the cam in? It's +4, does it go straight In or do I have to set it?
Finishing it tomorrow just need to put intake manifold in and finish bolting stuff up , just waiting on Johan's tune. The cam slid right out and we slid the new cam right in without removing the heads. Sorry no write up. Here's some pics of my buddy working lol
That sounds nice. I've got a 224/228 on a 112 from Andy waiting to go in the wife's. Unless I trade it on that super bee, which I'm strongly considering.
I actually traded my wife's Jeep in on the Super Bee before I ever installed it. I did have a set of Eagle heads that were going to be going on with it, only reason I say that is because IIRC 6.1 heads have a larger piston to valve clearance than the Eagle heads & this was about the largest cam I could use with the Eagle heads & stock short block. Based on what I remember this would be a good cam for 6.1 (stock heads) but you would most likely need to do springs, as you should with any cam swap.
PM Ekaz &/or Andy on here & they can confirm all the specs. You may be able to go with a bigger cam on the 6.1 heads.