Has anyone else had trouble with setting memory positions and linking remote keyless entry transmitter to memory? and/or setting the easy/entry seat?

I can only get driver memory 2 to register correctly, and I can't get the easy/entry to work at all. (It did work before I tried setting this up.)

everything is set to "yes" in the EVIC.

Has anyone else had trouble with setting memory positions and linking remote keyless entry transmitter to memory? and/or setting the easy/entry seat?

I can only get driver memory 2 to register correctly, and I can't get the easy/entry to work at all. (It did work before I tried setting this up.)

everything is set to "yes" in the EVIC.

Try turning off the easy entry and then set the link the keyless entry. After you get it linked, then turn the easy entry back on.

I finally stopped using the easy entry because it seemed to "forget" to go all the way forward to my correct seat setting.

Thanks - It helped with driver memory setting #1 but I still can't get the easy entry to work. Is there a "factory" reset default? Maybe I could start from scratch...

Thanks - It helped with driver memory setting #1 but I still can't get the easy entry to work. Is there a "factory" reset default? Maybe I could start from scratch...

If your seat is too far back, easy entry will not activate.

sucks for tall people like me

I think i've got an issue with the memory "S" and #1 switch. Sometimes it registers, sometimes not. I've got to believe that it has something to do with the easy entry/exit and linking the key.

I dont know if you've seen this yet, but this may be the answer to your problem

http://www.wkjeeps.com/tsb/tsb_wk_0802406.pdf

hope it helps

big help! - thanks. I've got some other "auto" setting issues that a start from scratch flash looks like the way to go.