While changing the pcm, I lost one of the two bolts that hold the computer to the wall. How can I get another one? I put both on the fender lip and they rolled inside the fender. Only one came out the bottom!!

Thanks

Have you drove it yet? If not, try moving it a bit while stopping quick, that may jar the bolt loose. Then if you have a magnet(extendable would be better) search for it.

I will try that tomorrow. I cannot believe the bolt fell thru such a small area.

Just order another from the dealer and hope the one you lost doesn't end up stuck in a tire.

While changing the pcm, I lost one of the two bolts that hold the computer to the wall. How can I get another one? I put both on the fender lip and they rolled inside the fender. Only one came out the bottom!!

Thanks Not stupid!
That falls under $hit happens.
It will workout, worse case the PCM will not fall off with one bolt and that plastic pin until the dealer gets a new bolt.
Bill

thanks I will try the dealer tomorrow.

At least you can get yours off. The UK/Euro spec has an extra restraint bracket holding the PCM in place and there is no easy way to remove it.
2004

At least you can get yours off. The UK/Euro spec has an extra restraint bracket holding the PCM in place and there is no easy way to remove it.
2004 Mark,
I have designed a neat piece to replace that "thing". Its function is the same (extra assurance from cables coming loose under extreme conditions) as that mess, but is very simple.
I will get it installed in the next few days and start a thread on it.
Bill

Dont feel too stoopid...I drop stuff all the time when I am working on the cars. I bet my job time would be cut in half if I could just hold on the the shiznit. It take less than a second to drop a wrench, but sometime upwards of a half hour to fish it out. :(