So I think I am finally going to get around to installing my Aux tranny cooler this weekend. I did some investigating and was hoping someone would be able to confirm the flow of the transmission fluid through the existing radiator.

Here is a pic of the cooling system.
http://lh4.google.com/image/eric.dieterich/Rke00GgITBI/AAAAAAAAAAs/nKoH4Imsq1g/s400/Transmission%20Small%201.JPG


Here is a close up of where the tranmission fluid connects to the cooler. What is the best way to determine the flow of transmission fluid through the cooler? Can I assume it will follow the same direction as the LX models, in through the top tube, out the bottom tube (I am refering to the steel (silver) tubes)?
http://lh4.google.com/image/eric.dieterich/Rke01GgITCI/AAAAAAAAAA0/umy4ksBqc7Q/s400/Transmission%20Small%202.JPG


I followed the tubes back until they change to rubber hosing (two black rubber hoses towards the bottom of the picture). This is the point I will tap into them for the new Trans cooler that I plan to hook up in series.
http://lh3.google.com/image/eric.dieterich/Rke022gITEI/AAAAAAAAABE/1xKbRO7PD7Q/s400/Transmission%20Small%204.JPG

pics dont work

pics dont work

That was my first time trying to embed some pictures. Took a little work but they should be viewable now.

That was my first time trying to embed some pictures. Took a little work but they should be viewable now.


they work now..