Can someone tell me how to get the side moldings off. I pulled and pulled until I could see the sheet metal bending and those suckers would not pop off. Is there a trick to getting them off?

pull your door panels off and push them through from the inside of the door to keep from damaging.

I thought of that but I don't want to get involved in that.

the inside panel is really easy to remove...the front doors have 3 screws and push in pins and the back doors have 2 screws and push in pins. Once yuo remove the screws the panels just pop off.

Thanks for the help, I ended up pulling a little harder and they popped off. I did break a few of the clips off but used the glue gun and it worked great.

run them over with my truck. im available any time ;)
http://i168.photobucket.com/albums/u179/tommy25000/327436025_16ca59dd1c_o.jpg

Are your refering to the green one in the back ground? There is a damn Ford in the way.. :D

funny you should comment. the one is the background is a rare 4 door short bed bronco. 2 tranny two trans case. bi block. 1 million " tires:D