It is hard to watch this being done, But the result should be good.

Dyno on Tuesday

http://web.mac.com/drivenphotography/iWeb/Family%20Site/Photos.html

I know a lot of us will be waiting. :cool:

Fast:

Based on the pics, its look'n like a job that any novice mechanic could handle at home, right up there with the Mopar CAI install! Seriously, very much looking forward to the results as well. High on my list of mods if yours and other members' results appear to be consistent with eKool's initial report/dyno. Thanks.

Fast:

Based on the pics, its look'n like a job that any novice mechanic could handle at home, right up there with the Mopar CAI install! Seriously, very much looking forward to the results as well. High on my list of mods if yours and other members' results appear to be consistent with eKool's initial report/dyno. Thanks.


I think it is more difficult for me to watch then for them to install;)

I will tell you if you want to do headers this is the easier way to get them in. With out removing the heads its a tight tight fit.

so if anyone does heads do the headers at the same time.

Nice pics. How many miles on the motor. Was that normal wear on the pistons. I'm an engine novice.

Thanks

T-Time

That takes big Kohonas my friend, hurts to look at that. Good luck and be careful.

It only has 8500k on it. I have only been driving it since 4k on it. I am guessing the nice coating on the pistons is normal. I have seen worse i have seen better.

I drive the jeep hard but I am sure no harder than anyone else here:D