AJ,

Wondering which springs, retainers and pushrods are needed to run the Orange cams? Looking at either the CC645 or 646.

Currently running Comp 26918s with Steel retainers and stock pushrods with my CompCam. I know they aren't rated to handle more then .600 lift.

Last thing, will either of these work with a Positive displacement blower or am I wasting my time even looking them?

Oh yeah, please respond to my PM about the Dyno Tune. :D

Thanks.

AJ,

Wondering which springs, retainers and pushrods are needed to run the Orange cams? Looking at either the CC645 or 646.

Currently running Comp 26918s with Steel retainers and stock pushrods with my CompCam. I know they aren't rated to handle more then .600 lift.

Last thing, will either of these work with a Positive displacement blower or am I wasting my time even looking them?

Oh yeah, please respond to my PM about the Dyno Tune. :D

Thanks.

Mike:
We have a spring and pushrod package available. I think the 645 is not the best choice for forced induction but the 607 would be a good choice. PM sent!!
A.J.

Thanks AJ. We'll discuss it when we hook up. The Comp is too small and is dying on the topend, so I wanna go bigger with the KB.