Thanks alot Tom, Today i was trying to get my underdrive pully installed and it got jammed on the crank shaft and it just would not fit,so i tryied calling the place i got it from but never got a call back so i tryied Tom @MHP and he helped me out answered all my questions and helped me get the pully back off.Hes helped me out with the whole build and did not have to,But he still did. Tom your a great help and thanks alot!!!!!!!!!!

Newfie.

Great to hear what was the problem that u had.

The underdrive would not fit on the crank shaft,so when i got it off i sanded down the inside ofit for about 5 min and the it went on,but for the life of me it would not come off so with toms help it worked.

Newfie.

Bro, its not suppose to fit over the crankshaft snout easily. Its called a pressed fit, that sandpaper trick might just bite you on the backside. If it was that tight and couldnt be installed properly, you shoud have sent it back to have it measured to make sure things were on spec.

Bro, its not suppose to fit over the crankshaft snout easily. Its called a pressed fit, that sandpaper trick might just bite you on the backside. If it was that tight and couldnt be installed properly, you shoud have sent it back to have it measured to make sure things were on spec.


Trust me i know that,but it was to the point it would stall out my impact,it just dident want to go on,but just to clairify its still very tight but worked with the sand paper taking off just enough .

Newfie