|
BD997 02-24-2009, 06:37 PM I have an '09 with factory HID adaptive lighting...Do I have to pull the entire headlight unit out in order to change the bulbs? I want to get sylvania silver bulbs for the front blinkers..... I hate that orange sh*t... I also want to change my HID bulbs to 8000k.... thanks scottina06 02-24-2009, 06:43 PM pull the rubber cover off, unclip the bulb(held in with tension clips) and pull it out. the turn bulbs just twist out--- BD997 02-25-2009, 07:36 PM pull the rubber cover off, unclip the bulb(held in with tension clips) and pull it out. the turn bulbs just twist out--- cool... when I had my '08 escalade I actually had to have my body guy pull the bumper off in order to pull the headlight unit out to replace bulbs... pain in the a$$ maansy 02-26-2009, 02:26 PM the battery side is kinda tricky thu, you might have to move the battery a little to fit your hand in good luck :) AZDEUCE 02-27-2009, 08:22 PM It is really a 4 min per bulb..the turns just pull out,not twist....try not to touch the bulb,or wipe it clean..your fingers have oil on them... BD997 03-08-2009, 07:16 PM It is really a 4 min per bulb..the turns just pull out,not twist....try not to touch the bulb,or wipe it clean..your fingers have oil on them... you guys must have small hands... I could barely change the bottom blinkers nevermind removing the rubber cap and pulling out the xenon bulb... no room at all... They must be pulled out atleast a few inches. maansy 03-08-2009, 07:59 PM hehe, only the battery side was a pain. had to move the battery a little :) | ||