Can you guys answer these for me...


Factory offset. Bolt pattern.



Factory wheel width/height, etc…

Factory wheels:

20 x 9 front, 20 x 10 rear. Bolt pattern is 5 x 5 (5 x 127). Offset is 34.75 (front) and 50 (rear). The tires have a circumference of 91 inches and a diameter of 29 inches (front and rear).

You sir. are THE MAN

For those that have experience with wheel fitments, do see it possible to fit a 20x11" rear rim? How wide will fit do think?

I haven't seen anyone try it yet, but I think it could be done. I am running a 10.5 in the back, and just went out and looked under the car. There is plenty of room (maybe an inch and a half or so) between the tire and the shock. I'm only running a 295, and I'm guessing that if you're wanting an 11 back there that you are thinking of maybe a 325? I think it could be done, but I don't have any personal experience with that size.

the problem in the rear is not the shock, but the end link, and the upper spring perch which protrudes out from the frame rail. i don't think you can go back much more than 5-10mm from stock. if you have 22's, you might clear that end link, but the upper spring perch will still be a problem as the wheel moves through its travel.

Im going with a 22x10 all around...ill keep you guys updated, this should be interesting

what type of rims?

Anyone know what the hub is? and the clearence from the tire to the fender

It's the part that the lugs protrude from.

Im going with a 22x10 all around...ill keep you guys updated, this should be interesting

Make sure your tire sizes are almost exactly the same proportionally as the stock sizes. In other words the front and back tires are the same size difference in diameter as stock. :rolleyes:

Hub size...76.1 is regular cherokee i assume its the same

Make sure your tire sizes are almost exactly the same proportionally as the stock sizes. In other words the front and back tires are the same size difference in diameter as stock. :rolleyes:

y? whats issue will i have with 285/35/22

Running a single tire size all around will cause you no problems. Your speedo could be a touch off, but that's it. I believe he was warning you against running different OD in the front and rear, but since you're opting not to stagger, you won't have that issue to worry about.

Running the C5-1 wheel in all black should come out nice...wheels will be here next week and ill get pics up ASAP. going to take a bit of work but i think the end result will be awesome

Did I miss it, or did you tell us what offset they are? Nice looking wheel.

the wheel is a Et50 so i wont have problems with the rears, i just have to do some work on the fronts

They'll look great. Can't wait to see them!

the hub bore is 71.4mm

the wheel is a Et50 so i wont have problems with the rears, i just have to do some work on the fronts

nick,
you will want to run at least 15mm spacers in the front, to keep the wheel from hitting the suspension. the wheels will stick out at that point, so you will probably need to run a 25mm spacer in the rear to make them look even.

those wheels will look really nice because they will look bigger than 3-piece 22's.

who makes those wheels and where are you getting them from? Do they make a 20x9 or 8.5?

nevermind, i found them. Pricey.

Bump for pics!

TTT

Lets see the pics :)