My passenger window rolls up about 1/3, hangs, the rolls back down about an inch. Then, if I hold the switch up it will go all the way up. If I use the auto up, it just goes up about 1/3 and stops.
I have disconnected the battery which should serve to reset it. I have rolled it all the way up and held the switch to reset the stops. No luck, though. Any ideas anyone?

Theres A Service Bulletin On That As Mine On The Drivers Side Was Doing It And They Fixed Under Warranty

http://www.wkjeeps.com/tsb/tsb_wk_2300108a.pdf

They did both sides of my 007. I got regulators, all new rubber.
Been OK for 6 months.

Rob

here you go bro!

http://www.wkjeeps.com/tsb/tsb_wk_2300108.pdf

http://www.wkjeeps.com/tsb/tsb_wk_2300108a.pdf

They did both sides of my 007. I got regulators, all new rubber.
Been OK for 6 months.

Rob

oh man! you beat me to it:D:p

Thanks, ya'll. I read it and I'll have the replacements done next time it's in the shop.

My Dad's truck had the same problem. Dealer replaced a module and something in the doors.

thanks i got to get mine done also they dont go up at all in automatic