Lifetime Premium Member
Join Date: Dec 2007
Thanked 5 Times in 5 Posts
Unfortunately you're going to be waiting a long time!
I actually went and bought one and had it here for two weeks, solely for the purposes of having it in hand so that I could take a whole series of trial dimensions, plus do the touchy feely deal.
Having it right close by gave me the opportunity to actually do some sight line fitting as having just a bunch of dimensions on a piece of paper just isn't the same.
After taking every conceivable dimension, and exploring every possible change I would have to make, I decided against pursuing the install any further.
There are two main issues to consider;
-the actual pocket available for the H/U to fit into. In the WK1s there is lots of width and depth, but the height just isn't there. I would have to cut much of the inner superstructure of the dash out, most specifically the section above the radio area. I'm just not prepared to cut all that out as it will weaken the under-dash area.
-the INE-Z928HD is not symmetrical in the front plate section relative to the chassis, in that there is more of the actual display hanging below the chassis than above. This means that the whole dash accessory control module would have to be moved down by at least 1/2", minimum, 3/4" being better. Unfortunately there's nowhere to go with that module, so this brought the whole episode to a halt!
And this really cheeses me off because I wanted to go with the 8" display.
Now, where does your '13 stand, I'm not sure. You will have to pull the MyGig out to get a feel for what space you have to play with.
Last edited by MLB12; 01-03-2013 at 06:35 PM.